PeopleTools 8.53 : Install Oracle WebLogic 10.3.6.0 on Windows 7

by Prashant on April 23, 2013

in General, PeopleSoft Administration

Oracle WebLogic is required to install PeopleSoft Pure Internet Architecture (PIA). Download the software from Oracle’s Edelivery site and then install it in 64-bit mode.

clip_image002

Note: By default if you run the setup, it will install the WebLogic Software in 32-bit. To Install it in 64-bit mode, you would need to install JDK 64-bit and then run the WebLogic setup as shown below.

clip_image002[5]

Click ‘Next’

clip_image004

Choose the directory where you want to WebLogic

clip_image006

If you want to receive updates from the Oracle, enter your email id here.  Click ‘Next’

clip_image008

Enter proxy info, if needed.

clip_image010

Choose ‘Typical’ and Click ‘Next’

clip_image014

In the next step, you need to browse the path for JDK 64-bit which you would have installed before starting WebLogic Installation. Click ‘Next

clip_image016

Choose the installation directories

clip_image018

Click ‘Next

clip_image020

Review the selection and click ‘Next’ to start installation of WebLogic 10.3.6

clip_image022

You will see the progress bar during the installation.

clip_image024

In few minutes, installation will be finished.

clip_image026

Oracle WebLogic 10.3.6.0 installation on Windows7 is complete now.

Related Posts Plugin for WordPress, Blogger...

{ 0 comments… add one now }

Leave a Comment

Previous post:

Next post: